IMPORTANT: Always SWITCH OFF and UNPLUG the CardBot before conducting any maintenance. DO NOT TOUCH any of the wiring or circuit boards while the CardBot is plugged into power.
You can remove the roof from your CardBot. This gives you access to the pickup head and gantry, and some of the electronics.
Items:
1 x 2.5mm hex key
1 x Flashlight (optional)
Steps:
Remove the door and set it aside
Using the 2.5mm hex key, undo the 2 bolts at the back of the roof and the 2 bolts at the top of each side panel - place them aside
Gently tilt the roof forward and lift/wiggle upwards to move the bolts on the inside of the faceplate to the top of their slots (you can look underneath to see these - you may need a flashlight)
Gently pull the roof forwards to pull the bolts out of the keyholes
Replace the roof by reversing the steps - slot faceplate bolts back into the keyholes, wiggle the roof downwards so that the holes for the 6 bolts are roughly in line, then screw in the bolts (get all of the bolts in loosely and then fully tighten them) with the 2.5mm hex key